DIY

All

JELSCO Wiring Diagram

JELSCO Wiring Diagram

Wiring Diagram using the JELSCO LED Driver with Dimmer  1. Connect LED Driver to power source.  This will be the standard power you have in your home generally 120 Volts 2. Plug in dimmer This is optional and can be left out 3. Connect Numbers Connect all Red wires into a wiring nut with a lead to the connector Connect all Blue wires into a wiring nut with a lead to the connector   With Wire in LED Driver With Plug in LED Driver

Keep reading →

Backlit House Number install

Backlit House Number install

After seeing another guide i wanted to update my house numbers to something modern as well as practical. I constantly have delivery drivers drive right past my house as i have shrubbery and sit a bit off the road.  My requirements : Something bigger then standard numbers Something that would be visible at night Water Proof Materials: Led Numbers by JELSCO  Water Proof Led Driver  Plywood Screws Rust-oleum Spray paint Wiring Caps Wire Strippers Tools: Drill Drill bits - 3/8 & 5/32 Saw Volt Meter Step 1: Mounting I wanted...

Keep reading →

Led House number install

Led House number install

Delivery drivers always have trouble finding our house as it is set far back from the street so I created this backlit house number post. My requirements were: Powered by 12VAC landscape lighting Easily visible from the street Distinctive look to catch the eye of guests Building Materials: Cedar Fence posts x 4 1in x 1in framing boards x 4 1.5 in outdoor fence screws Metal Fence post Low voltage landscape wire Spray paint Painters tape and masking Tools: Drill Wire strippers Tape Measure Ruler Level Sharpie Caveat: Low voltage...

Keep reading →